Our kind assistant in movement in Mother Earth, at the most inopportune moment, is able to not obey the ignition key and we immediately appear panic. One driver immediately begins to seek the cause, and the other begins to turn the ignition key again and again and as a result, after a few minutes, the battery "CD". In order not to plant the battery, calm down and check the most basic signs by which the machine does not start. Find a problem - it will be possible to solve it.

The car does not start, the reason is a simple situation.

The very first reason, due to which the machine does not start - the absence of fuel.

So, immediately look at the readings of the fuel level sensor, if the sensor is at a minimum, it means that the motor does not receive fuel.

Take into the hands of a canister or a small bottle and "chesh" on the gas station.

But, you need to know the readings of your sensor, whether it turns on the level of fuel in your machine.

If everything is fine with fuel, carefully inspect the dashboard, your car.

The dashboard is very dull, and turning the key, you see that the bulbs are immediately dug - it means "buggy" battery. Find a way to recharge it.

And you can recharge in different ways:

-Replacement device with a built-in battery;

- with the help of a home converter by 12 volts, which connects to the household network;

- If you are in the garage, charge the battery in place, and if you can turn to a hundred outside the garage;

- Using special wires with clamps, contact your neighbor asking "Allow seen" from your car;

- If there is no help from the side, you can call a taxi, but you need to warn that the taxi is needed for "cursing". A taxi driver, of course, will take a fee for this, but not greater.

And if there is a fuel, the battery is working, and the car does not start - open the hood and carefully inspect the electrical wires of the machine, it is possible with any terminal with a wire.

If your car is on the "mechanics", and not start because of the battery - try running the machine with "push".

If the machine is in a flat place or before lifting, you will have to use the help of one or two people.

The driver gets behind the wheel, includes the second gear, keeps the clutch pedal pressed, and helpers at this time push the car from behind. When the car picks up speed, release the clutch pedal.

And if there are no assistants, it will have to lie down his hands in the head of the windshield and push the car by himself, putting a car on a neutral speed, and so much time to cheer.

As soon as the car drops speed, jump inside, turn on the second gear and if the car becomes, let it work for 5-10 minutes on medium turns.

For a TV to start a car with "push", you can use the help of a neighbor and towing cable

The car does not start, the starter does not twist

If you do not hear the sound of the starter, i.e. It does not twist at all, or is moving very sluggish - once again inspect the electrical system.

Take a look at the battery terminals, they can be very much oxidized and not capable of using the desired current on the starter to start the car.

If the terminals are oxidized - take a sharp knife or sandpaper and clean the terminals to the metal shine, besides this, pay attention to how the bolts are tightly tightly tightened on the battery.

If the battery is in order, pay attention to the starter. The problem may be in the wiring and relay.

When turning the ignition key, clicks must be heard, one click will be barely heard, and the second click must be heard clearly.

If the sound is not heard, replace the relay, as if there is no loud click, this indicates a breakdown of the retractor inside the starter case.

If the machine does not start, remove the wire from the starter, which goes from the ignition lock and using the multimeter, check whether there is a voltage when the key turns.

If there is no voltage, it is necessary to take a piece of the wire and connect the direct terminal of the retractor relay with the battery, with a closed electrocuprup machine. If, when you turn on the starter, the wires are very hot - contact the car service.

The machine does not start, the ignition system does not work

If the machine does not start from the ignition key, but the starter is spinning - check the ignition system.

Pay attention to the ignition coil, high-voltage wires, inspect the candles, switch and rubber - if there is humidity, remove the moisture with a rag and wait for complete drying.

Check the protective ignition coil casing and damage to high-voltage wires.

Check the candle for the presence of a spark, to do it and compose it with high-voltage wire.

If when you turn the key in the spark lock lock, you will have to remove the wire that leaves the coil or from the switch, then put it on the metal and turn the key again.

If the spark does not appear, you will have to change all the details.

But it is possible that the spark is missing because of a strong carnival on the candle, in this case, the candle must be cleaned and rolled 10 minutes on the gas stove.

In the event that the candles of cars flooded with fuel, they need to be unscrewed and dried.

The machine does not start, there is no fuel supply

If the car started and immediately stalled - it is often a bad work of the fuel system or control electronics.

If electronics does not work, you will have to contact the maintenance station.

But the fuel system may not work well, check the operation of the fuel pump.

If the fuel pump is not heard when the ignition key turns out, disconnect the incoming fuel filter hose and turn on the starter for 2-3 seconds - a powerful jet of fuel will go out of the hose.

If the jet is available, put the filter into place and repeat the procedure by removing the hose from the filter output.

If the jets are not, it is necessary to blow well or change this piece of machine.

If a carburetor engine does not start, remove the air filter and check the condition of the carburetor.

The carburetor is scored - clean it and bring the carburetor into an efficient condition.

When the injector fuel system, in the event of a malfunction, check enqine will light up on the panel. If fuel passes through the fuel filter safely, it means there is a malfunction in the distant stages and only a specialist can eliminate this malfunction.

If you have a car with a diesel engine, it starts and then it stalls immediately - immediately go to the maintenance station. You can check only the operation of incandescent candles, and check the thickness of the diesel fuel.

If the diesel fuel poured not within the season, you will need a special additive.