A situation where the dashboard on the car VAZ 2110 is not working, it is not uncommon for the domestic auto industry products. Any vehicle not without sin, so motorists have no choice but how to deal with the emerging time after time faults. About this further in the article.

The instrument panel 2110, a description of how devices are mounted on the panel plate

1. coolant temperature (coolant) in degrees Celsius.
2. The tachometer indicates speed powertrain.
3. Left turn indicator.
4. right turn indicator.
5. Speedometer indicates a vehicle speed in km / h.
6. Fuel reserve indicator indicates the fuel level in the tank. If there is 5-7 liters, lights corresponding to the yellow light - a warning or an icon, which shows the gas station.
7. Actually this is the image of a gas station, which indicates the need for refueling.
8. Control dimensions enable light.
9. The indicator indicates low brake fluid level, propelled this lamp is prohibited.
10. Enabling beam headlamps.
11. Watch eyelid knob, in some cases this handle executes the daily mileage / common run (if the panel with a narrow display).
12. A display that displays daily mileage / common mileage (may be narrow on some models).
13. Alarm control light.
14. Check Engine, often indicated by the next icon What does a malfunction in the motor, it is recommended to stop the operation of the power unit.
15. A clock display (with a temperature sensor, can display air temperature overboard).
16. Rechargeable battery charge indicator. It lights up when electrical equipment begins to function from the battery. It may indicate a weakening of either the broken belt of the generator, the malfunction of the generator, the break of the chain and other malfunctions.
17. The indicator that lights up when the parking brake is turned on.
18. Oil pressure indicator. It lights up when the oil pressure in the motor lubricant is dropped below the norm. It is unacceptable to exploit the engine with a burning lamp. Check the filter service and the level of engine oil.
19. Air damper lamp (only on carburetor motors).

The instrument panel of the VAZ 2110 of the old sample and the instrument panel of the VAZ 2110 of the new sample, which difference

The instrument shields mounted on the VAZ 2110 are of two variations - an old sample and a new sample, which depends on the year in which the vehicle was released.

Their difference is that on the dashboard of the old sample, all devices are placed symmetrically, and on the shield of the new sample - the pointers of the coolant and fuel are shifted to the right-hand side of the panel.

VAZ 2110 instrument panel does not work, devices and control lamps do not work. Causes

The most significant malfunction of the instrument panel is its absolute failure. In this case, neither the devices nor the control lamps do not function, the pointers do not work, and the arrows fall down. To eliminate the problem, first of all, it is necessary to check fifteen ampere fuse, indicated by F6. Most often it is precisely he is the reason for the failure of the instrument panel.

Fastened fuse F6, how to find the cause to pay attention to

As already mentioned above, blown fuse F6 entails a complete site failure. You can find it in the mounting block. If this element is blown, you should look for the cause of this phenomenon, otherwise a new fuse will repeat the fate of the previous one, t. E. Also burn. The reason blown fuse usually is trivial circuit Electrical circuit.

Jumping arrows instruments, the reasons

There are situations where the arrow devices jump on its scale from high to low. In most cases, the cause of such a phenomenon is a bad connection (contact) with the mass. Wire mass extending from the dashboard, attached to the partition that separates the engine compartment from the passenger compartment. You can find it and seized the radio out of the slot. However, if your vehicle is installed alarm, it is likely that for the convenience of mounting this mass wire transferred to another place, more affordable. Alarm installers tend to rearrange it for interior trim in the area of \u200b\u200bthe driver's left foot.

The same picture is also possible when installing the radio. When joining its minus cable earth wire spun dashboard, whereupon it poorly wrapped. Because of this, under the influence of vibrations that are transmitted to the vehicle body, it is weakened. It is worth noting that his poorly wrapped due to the fact that it is not very easy to do.

Fastening wire of weight, how to check the contacts

If mounting a mass wire quality will have to check the dashboard itself. To do this, it needs to get to a place of fastening on as much as possible, without disconnecting the wires that go to the stocks. Check earth wire must be on board the white X1 coming to the first contact. Furthermore, it should check the voltage on these pins - 6, 9, 10, which must be equal to twelve volts. Note the integrity of the tracks on the rear side of the dashboard, on which current is supplied to consumers.

Stopped working cigarette lighter, what is the connection with the refusal of the panel boards

Another reason for not working the instrument panel - the cigarette lighter. The problem is that through this connector is connected motorists some additional devices, in particular vacuum cleaner automobile cabin, bus electric pump, a cell phone charger. Given that the data users need a large current, it breaks down or he's cigarette lighter or fuse blows F19, because of what and denies the instrument panel. It should be noted that the output from the cigarette lighter system can also be extended by holding it in the ON position. In such cases, make the dashboard can work by separating the connector cigarette lighter, but if not burned out fuse F19.

Tips Prof.

As you can see, to eliminate all the problems associated with the absolute refusal of the work of the dashboard, the car owner can himself. To do this, he does not need any additional knowledge in electrical engineering. The only thing they should know is the possible causes of such a failure.