Fuses and relays VAZ 2110, fuse diagram and relays, where they are

If your vehicle is not started, the turn signals stopped turning on, the wiper brushes do not work either, for example, the heater refuses to work, then the first thing to be done is to pay attention to the state of the fuses, that is, to see if they are unloaded. The car may not start, because the starter or fuel pump fuses burned, the heater motor also has its own fuse. Often, the fuse of the cigarette lighter suffers from the high load, which on the VAZ 2110 has to change quite often. About this further in the article.

Relays and fuses VAZ 2110, where they are

On the VAZ-2110, the relay and bloc of fuses are located in the vehicle cabin slightly higher and the left pedal.

VAZ 2110 fuses and relays, location scheme with decoding

004-1knuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuug9555555555555555555555555555.

Location of fuses and relays in the Mounting unit of the car VAZ 2110:

  1. Relay control of a good condition of the light bulbs - K1.
  2. Front janitor relays - K2.
  3. Relay interrupter of alarm signaling and rotation pointers - K3.
  4. Launch Launch Launch Relay - K4.
  5. Far light headlight launch relays - K5.
  6. Additional relay - K6.
  7. Relay launch of the rear window heating - K7.
  8. Relay fog lamps - K8.
  9. Fuse fuses - F1-F20 - in fact, all vehicle chains are protected by fuses, which are designed for different rated currents. The exceptions are the following chains - ignition and motor start, the generator circuit, in addition to the excitation winding, the battery charge circuit.

How to find a burnt fuse

To find the burned fuse, you must use the scheme below. Before this, you should detect the cause of the burnt fuse and eliminate it, after which you can install a new fuse.

Tables of chains of fuses VAZ 2110

  1. Light bulbs lighting lighting numbers. Light bulbs of devices. The control light of the overall light. Trunk lighting light bulb. Light bulbs of overall light on the left side - F1 (5 amps).
  2. Middle Light of the left headlamp - F2 (7.5 amps).
  3. Far Light left headlamp - F3 (10 amp).
  4. Right fog light - F4 (10 amp).
  5. Electromotors of doors windows - F5 (30 amperes).
  6. Portable lamp, cigarette lighter - F6 (15 amp).
  7. Motor cooling fan fan electromotor. Sound signal. - F7 (20 amperes).
  8. Contacts (relays) of launch of rear window heating - F8 (20 amp).
  9. Winding (relay) launch of rear window heating. Recycling valve. Washers and headlights and windscreen cleaners (wipers fuse) - F9 (20 amp).
  10. Reserve - F10 (20 amp).
  11. Light bulbs of overall light on the right side - F11 (5 amps).
  12. Middle Light of the right headlight - F12 (7.5 amps).
  13. Far light of the right headlight. Far Light Launch Control Light - F13 (10 amp).
  14. Left fog lights - F14 (10 amp).
  15. Blocking the trunk lock. Electric heating seats - F15 (20 amperes).
  16. Relay-disgrace of alarm and rotation pointers (alarm mode). Alarm control light - F16 (10 amp).
  17. Salon lighting light bulb. Individual light bulb. Ignition switch illumination light bulb. Stop light bulbs. Clock (or route computer) - F17 (7.5 amps).
  18. Blump light bulb. Cigarette lighter fuse. The controller (fuse) of the heater - F18 (25 amperes).
  19. Relay control of a good condition of the light bulbs of the overall light and stop signal. Lock lock locks. Reverse light bulb. Turning with control lights. Generator excitation winding. Combination of devices. Control system indication unit. Clock (or route computer) - F19 (10 amps).
  20. Light bulbs of the rear fog lamps - F20 (7.5 amps).

Additional block of relay and fuses of the fuel injection system, where are located

Additional relays and fuses are installed on the right side of the dashboard, behind the side cover of the console, which is attached using two screws.

004-1knuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuug9555555555555555555555555555.

Circuits of additional fuses and relay with conditional numbering

Additional fuses (all 15 amp):

004-1knuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuug9555555555555555555555555555.

  1. Controller, ignition module.
  2. Air flow sensor, oxygen sensor (heating), vehicle speed sensor, adsorber purge valve.
  3. Nozzles, fuel pump, fuel pump relay. Additional relays:
  4. Electric fan relay.
  5. Electric gas station relay.
  6. Ignition relay (main relay).

In the niche of the dashboard behind the mounting unit, the fuse of fog lamps is mounted.

004-1knuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuug9555555555555555555555555555.

Conditional numbering of plugs in connecting pads

004-1knuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuug9555555555555555555555555555.

Connection block circuit

004-1knuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuug9555555555555555555555555555.

The inner digit in the designation of the tip of the wire is the plug conditional number, and the outer digit is the number of the pads.

Tips Prof.

As for the replacement of the fuse, then everything is extremely simple. First you need to find a black box with an assembly block and click on the latch to open the lid. Carefully inspect the mounting block - in the middle there must be a special tweezers to extract fuses. Next, we find the fuse required by us, for example, a cigarette lighter fuse, that is, "F18". Then, using a tweezer, remove the burned item and install a new one.

Comments